ATTENTION: FadalVMCParts.com Has Been Retired
Click here to learn about the NXGEN Control at NXGENCNC.com

Best Quality - Best Price

1980 Oil/Air Board

 
     
 
lefttop
 

 

1980-0A
Air/Oil Board


Specs: Spindle Lube Controller

 

Spindle Lube Controller

 Controls the Air/Oil Spindle Lubrication


Three Purchase Options:

- NEW
- REMANUFACTURED, off the shelf exchange
- REPAIR, best savings with fast turnaround

Specifications:
Part Number
    - PCB-0157 Air/Oil Lurication Control Board
   
- Remanufactured
    - One Year Warranty
    - Tested and Warranty by ITS


About the Air/Oil Board:
The air/oil spindle lubrication system operates automatically using the 1980-0 control board. The pressure switches will cause an emergency stop condition if the system is not operating properly.
For more information, see the MANUALS section in the site about the Spindle Drive system.


True Knowledge and Experience you can Trust:
 

Experience - Always Your Best Choice:
Having been involved in the original design and production of the CNC88 hardware and software, we truly understand these boards; to the component level and the requirements for properly repairing and testing of all the boards we offer. With over 18 years of production testing and repairing CNC88 boards, there is none better experienced or equipped than ITS.
Independent Technology Service Inc. (ITS), the original PCB board house for Fadal, has been testing and repairing the production boards, since 1991.

 On your board, chances are you'll see the stamp already on it!

Before You Buy - Ask how the Fadal board was tested!
One simple question can save you a lot of frustration, wasted time and money when servicing a problematic machine. The common "repair" method today for others selling boards is to put a used board in a machine and see if it fails. It cannot be considered a "good board" just because the control doesn't fault. Most of the time there is no history of the board, no record of past performance (problems).
In fact, without proper testing, chances are you will be getting other unknown board problems when installing used, untested boards; wasting even more of your time and money!

Testing That Is Unsurpassed!
We are the only ones who can properly test and repair CNC88 boards!  It requires component level testing to verify that each and every component is performing to original specifications.

The Best And Only Way - In Circuit and Functional Testing:
The testing of electric circuits to determine and locate any of the following circuit conditions:
  (1) an open circuit.
  (2) a short circuit with another conductor in the same circuit.
  (3) a ground, which is a short circuit between a conductor and ground.
  (4) leakage (a high-resistance path across a portion of the circuit, to another circuit, or to ground).
  (5) a cross (a short circuit or leakage between conductors of different circuits).
  (6) a marginal or failed component(s).





The simple fact is that proper circuit testing for complex systems requires extensive automatic testing equipment to determine the failures defined above as well as many other quantities required to insure the board is working correctly.

CNC Board Replacement Options:
 1- New or Remanufactured exchanges are available for immediate shipping, requires core exchange.  A core refund is issued when we receive the bad pcb board.  The core return board must be in a state that is repairable not damaged.

 2- We will repair your board, for about 1/2 the cost of exchange replacement!  Rush repairs are available on most boards.








 

 


 

Request for Contact

Visit www.ITSCNC.com for prices and contact information.
If you need help, call us at 1-888-727-1887.

 

 


 

 

 

 

 

 
righttop